In the firmware version V1.25 for the KOSMIK 170/210/250 HV-I the following item has been added. No bootloader update is necessary for V1.25, provided V1.17 or higher is installed on your controller. If a lower version than V1.17 is on your controller, the bootloader update must be performed in advance as described below and only […]
For the KOLIBRI models (HV-I and LV-I) we have now made the new software V3.3 available for download. The new software enables active protection of the KOLIBRI’s electronic components during rapid load changes and avoids false overcurrent fault detection.In the event of a short-term motor blockage, for example, the current is reduced to zero. After […]
KOSMIK 170/210/250/300 HV / HV-I In the firmware version V1.18 for the KOSMIK 170/210/250/300 HV / HV-I the following points have been added and improved: To avoid errors and malfunctions during the update, the update process must be carried out as described below. The first step is to install the bootloader update on the KOSMIK […]
With the V3.0 software, convenient, direct parameterization via the remote control “VBAR Control Touch” or “VBAR Control Classic” is now also possible. This offers the great advantage of being able to try out different settings of the controller on the flying field! Other telemetry adjustments:
With the new bootloader, sending in a KOLIBRI controller for service in case of an unintentional interrupted or incomplete update is history! In order to use the new bootloader, the new controller software V3.0 must be installed on the KOLIBRI. Then the bootloader update to V3.0 must be performed as described below. The new bootloader […]
This software version is required to set up the KOLIBRI LV-I or HV-I with the V3.0 software and to load saved controller setups.
With the update of the software to version 2.1, the telemetry port and the Bluetooth function on the KOLIBRI LV-I can now be used simultaneously. With the previous software version, the Bluetooth function was only usable when the telemetry cable was disconnected. This improvement is significantly important for the KOLIBRI 140 LV-I, as it has […]
With the software update, we have integrated two new parameters for dynamic current control and peak current control into the boot loader to further improve the performance of the controller. The telemetry functions have also been expanded. With the software function 2.0 the data exchange with Futaba CGY760 and JETI CentralBOX has been improved. In […]
In version 1.2, a peak current control parameter has been integrated to improve the performance of the controller. The telemetry functions have also been expanded. With software function 1.2, data exchange is possible with: There are some special features to note with this software update. When downloading the software update, the virus scanner may report […]
In version 1.10 the telemetry functions for the KOSMIK 170/210/250/300 HV & HV-I have been extended. Data exchange is now also possible with: There are some special features to note with this software update. When downloading the software update, the virus scanner may report a virus . The software has been checked by KONTRONIK and […]
